Descripción
Tekbox EMCView – PC software for EMC pre-compliance testing
The Tekbox EMC compliance software EMCview for PCs is a user friendly EMC pre-compliance testing of radiated and conducted emissions. It is a perfect complement for automated testing using our LISNs and TEM Cells.
A built in amplitude correction enables correction and conversion coefficients for cables, amplifiers, attenuators, LISNs, TEM cells, antennas, RF current probes, striplines and capacitive coupling clamps.
There is no need for a time consuming setup. The SW is ready for measurements straight after installation. All emission related CISPR-xx (EN550xx) measurements and a few automotive manufacturer standards are pre-configured in corresponding project files.
The graph supports two complete measurement runs such as for example Average / Quasi-Peak or Peak / Quasi Peak and alternatively a fast Quasi-Peak scan of critical peaks.
Características principales:
- Numerous pre-configured project files for CISPR-xx (EN550xx) emission measurements.
- Graph supports two complete measurement runs, same as in test house.
- Fast Quasi-Peak scan of critical peaks, immune to frequency drift of the selected peaks.
- Configurable limit lines and segment files.
- Harmonics indicators lines.
- Configurable correction files for cable, LISN, amplifier, antenna etc.
- Configurable margins for the identification and selection of critical peaks.
- Supports import and overlaying of reference measurements for comparison purpose.
- Linear or logarithmic frequency axis.
- Automatic creation of test reports.
- Many import/export-functions.
